RGB+C+W light showing up as only C+W bulb
RGB+C+W light showing up as only C+W bulb
I have 4 RGB+C+W zigbee bulbs like this one:
However after adding it to home assistant, they only show up as c+w bulbs:
What am I doing wrong? How can I get it to detect it as RGB+C+W?
You're viewing a single thread.
-
What ZigBee Coordinator do you use? I know deconz and zigbee2mqtt have the ability to add support for new devices via config files. But that's a bit of a rabbit hole into the ZigBee protocol. They also have forums/issue trackers where one can request support for new devices.
-
I'm using the ZHA connector, these are Tuya bulbs, I've had good success with other Tuya products but alas. ~ Where would I requested support?
-
There is some documentation in the forum about how to add new device support or where to request it. Read it and then decide what to do.
-
I found someone who, just yesterday, submitted a device support request for my exact model! The request is here, I'll watch it for a bit.
-
-
-